Carpenter Canterbury-Bankstown | Dual Occupancy & Granny Flat Framing
Canterbury-Bankstown is an infill region, not a greenfield one. Almost nothing here is a blank lot. The work is what can be added to, replaced on, or built behind a block that already has a house on it — and that shapes every framing job we take on in the area.
Jirah Carpentry frames dual occupancies and secondary dwellings across the region, and does the structural carpentry behind full-house renovations. Set out from your plans, framed to the engineer's documentation.
For the Sydney-wide picture of how we work, read our Sydney carpenter page, or see every area we cover on service areas.
What gets framed in Canterbury-Bankstown
Four project types make up nearly all of our work here, and they are the same four we prioritise across every region we cover.
New Builds — Houses
Knockdown-rebuild house framing where the original dwelling has been removed and the replacement is a full new frame.
Duplex Framing
Dual-occupancy framing on subdivided blocks, with both dwellings sequenced together rather than one after the other.
Granny Flat Framing
Secondary dwellings on the deeper blocks common through the region, where rear access dictates the build sequence.
Renovations & Extensions
Structural carpentry for full-house renovations — walls opened up, new beams in, roof structure re-framed.
Deep blocks with houses already on them
Much of the region was subdivided a long time ago, which left a housing pattern of older single-storey homes on blocks that are narrow at the street but run a long way back. That depth is the reason secondary dwellings are so common here — there is genuinely room behind the existing house for another dwelling without crowding it.
It also means a lot of the renovation work is about the front house rather than the rear one. Homes of that age generally carry load on internal walls, so a modern open-plan renovation is a structural exercise: beams sized by an engineer, propping handled properly, and new framing tied into a structure that has been standing for decades.
Second storeys appear here too, though less often than in the Hills. Where they do, the existing roof comes off and the new floor and wall framing has to be set out from what is actually on site — not from what the original plans said.
Getting timber to the back of the block
On an infill site, the practical problem is rarely the frame. It is the driveway. A granny flat at the rear of an occupied property means every stick of timber comes past a house someone is living in, often down a driveway a car's width across, with a fence on one side and a wall on the other.
We plan that before we start: what gets delivered when, where it is stacked, and how the site stays usable for the owner while the frame goes up. It is unglamorous but it is the difference between a two-week job and a four-week one.
The same thinking applies to renovations on occupied homes. Sequencing the structural work so the house stays liveable is part of the job, and we will tell you honestly when a stage of the work means it will not be.
Documentation first, then setout
We read the architectural drawings and the engineering documentation together before pricing. On infill and renovation work we will also ask for photos of the existing structure, because an extension drawing shows the intent and the photos show the reality. Anything that does not reconcile gets raised with you before it is framed.
Setout is checked against the drawings before wall frames are stood, and checked again for square and plumb before final fixing. Bracing and tie-down go in to the engineer's detail. When the frame is done, we walk it with you while adjustments are still cheap.
Where this region sits in our coverage
Canterbury-Bankstown sits between our Western Sydney base and the southern and inner parts of the city, so it is comfortable territory for us on travel. Regions either side that we also cover include Western Sydney, the Inner West, St George and Macarthur.
For the framing detail rather than the region, read timber framing Sydney, house framing contractors or residential carpentry. Every area we cover is listed on service areas, and our Sydney carpenter page gives the whole picture.
Builders, developers and homeowners
A large part of our Canterbury-Bankstown work comes from builders and small developers doing dual occupancies and secondary dwellings, where the framing is a defined package inside a bigger build. The rest comes from owners adding to a family home or putting a granny flat at the back of one.
Both work the same way. Send the plans, get a quote for the framing scope and a start window we can hold. If you are a builder wanting a regular framing crew rather than a one-off, the work with us page covers how we take on trade work.
We are straightforward about what we are: a framing and structural carpentry crew. We do not run the build, we do not do fit-out or joinery, and we will tell you when a job needs a trade we are not.
Adding To A Block In Canterbury-Bankstown?
Send the plans through and we'll price the framing and tell you how we'd sequence it.